XGIMI 3D glasses guide

Charging time: approximately 2–3 hours If not used for a long period, charge the battery at least once every 2 months. Powering on the glasses: Press the power button once. The blue/green LED will flash once, indicating that the glasses are on. Working status: When operating, the blue/green LED remains off. Powering off the glasses: Press and hold the power button for 3 seconds, then release. The blue/green LED will flash 3 times, and the glasses will turn off. Standby mode: If no signal is detected for 5 seconds, the glasses enter standby mode, and the blue/green LED flashes once every 5 seconds. If no signal is detected for 5 minutes, the 3D glasses automatically turn off. Left/right eye switching: While operating, press the power button once to switch the left/right display. USB charging: Charge via the MicroUSB port. The red light stays on while charging and turns off when fully charged. Low battery alert: The blue/green LED flashes 5 times, then flashes every 10 seconds as a reminder. XGIMI 3D Glasses Setup: 1. After the projector starts playing 3D content, select the corresponding 3D mode. 2. Press the 3D glasses’ power button once to turn them on. 3. Put on the glasses and view the 3D image. If needed, press the glasses’ power button a few more times to adjust the left/right eye sequence to a comfortable state.