When the Picture Mode is set to Movie Mode, the projector will automatically enable this feature when it detects HDR10 content.
You can check the status of this feature by following these steps:
1. Play HDR10 content.
2. Press the Settings button on the remote control to open Quick Settings.
3. Select “Display”, make sure the Picture Mode is set to “Movie”.
4. Then scroll down to “Advanced Settings” and enter it.
5. At the bottom of the “Advanced Settings” list, you will find “HDR Dynamic Tone Mapping.”
---
Note:
- Only applies to HDR10 content
- Manual control of this feature is not supported.