1. When the projector is on an HDMI input source, press the Settings button on the remote control to open Quick Settings.
2. Select “Display”, then scroll down to “Advanced Settings” and enter it.
3. Scroll down to “Projector Super Frame” and make sure it is turned on.
4. Wait for the projector to switch modes
---
On your HDMI device:
- Set resolution to: 1920 × 1080
- Select refresh rate: 120Hz
---
Tip (PC users):
- Use Extended Display Mode
- Set the projector as the primary display
---
Note:
- High refresh rate is only supported at 1080p
