Position first, then optical, then digital. Three steps:
1. Position the projector: Place it as close to perpendicular to the wall or screen as possible; avoid side projection. See the distance and height recommendations above.
2. Optical zoom and lens shift: Use optical zoom to set the image size, then lens shift to move the image. Neither causes any loss in image quality.
3. Reposition, or finish with digital correction: If optical adjustment is at its limit and the image still does not fit, try moving the projector first; use manual keystone correction only for the small offset that remains.
Note
- Horizontal and vertical lens shift cannot both be set to maximum. To use the full vertical shift, the horizontal shift must be set to 0 — and vice versa. Aligning the lens center with the center of the screen avoids the need for horizontal shift and preserves the full vertical range.
- Digital zoom and manual keystone correction work by digitally cropping and warping the image. Heavy use will noticeably degrade image quality and produce a large visible ghost frame outside the projected image. Ideally, the projected image should be only slightly larger than the target before you apply them, so that minimal keystone correction is enough. With wide-angle side projection, a large ghost frame is unavoidable.